Please respect the Waste Electrical and Electronic Equipment regulations in your country. (2) this device must accept any interference received, including interference that may cause undesired operation. (1) This device may not cause harmful interference, and Operation is subject to the following two conditions: This device complies with part 15 of the FCC Rules. Modification of Terms and Conditions: Radio Systems Corporation reserves the right to change the terms, conditions and notices under which this Product is offered.Buyer assumes all risks and liability from the use of this Product. Limitation of Liability: In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive, incidental, special or consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this Product.Using this product in a way that is not intended could result in violation of Federal, State or local laws. This device is not intended to harm, injure or provoke. No Unlawful or Prohibited Use: This Product is designed for use with pets only.Proper use includes reviewing the entire Quick Start Guide for your product and any specific Caution statements. If you are unsure whether this is appropriate for your pet, please consult your veterinarian, certified trainer or contact our Customer Care Center or visit our website at. The specific temperament of your pet may not work with this Product. Proper Use: This Product is designed as a system for automatic dispensing of dry or semimoist pet food.Usage of this Product implies acceptance of all such terms, conditions and notices. Terms of Use: This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and notices contained herein.USA & Canada – Tel: 80 – Monday – Friday 8 AM – 8 PM / Saturday 9 AM – 5 PM Terms of Use and Limitation of Liability Remove both trays from the feeder before placing in the dishwasher. When “ ” stops flashing and stays on the display, the batteries are too low to operate the feeder.Replace all four batteries with new batteries, then reprogram the feeding times. When the battery power is low, “ ” will flash on the display instead of the countdown to the next meal time.Press any button to wake the LCD display. Once countdown begins, the LCD display will indicate how many hours (H) and/or minutes (M) until meal time.Īfter five minutes of inactivity, the LCD display will go into sleep mode to conserve battery power. The system will automatically save your selections and begin the countdown. Use the left or right set of + and – buttons, to set how many hours from now each lid should open.Example: Programming at 10 AM, if the first lid is set to 4H and the second lid set to 12H, the first will open at 2 PM and the second will open at 10 PM.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |